U-Joint Cap Holder

Stop using tape and stop worrying about your U-joint caps falling off!
This holder is made specifically for the 1310 U-joint and SPR 529 driveshaft — keeping all four caps secure and clean while stored or transported.

Why Racers Use It

✔ Built for 1310 U-Joint / SPR 529 setups
✔ No more tape on the ends of the driveshaft
✔ Keeps U-joint caps locked in place
✔ Prevents losing caps in the trailer or shop
✔ Saves time during repairs and change-outs

Product Highlights

• Holds all 4 caps firmly in position

• Quick on / quick off – no tools needed

• Made from high-temp, impact-resistant material

• Fits spare or installed driveshafts

• Track tested & racer approved

Please Note: Trackside 3D Printing by CA may take up to 1 week to fulfill your order after purchase. All parts are made to order and printed in the order they are received.

By purchasing and installing this product, you agree to the following:

Parts are provided as-is with no warranty expressed or implied Customer is responsible for proper installation and safe use Trackside 3D Printing by CA is not liable for any damage, injury, or failure Always inspect parts regularly before racing Installation should be performed by a qualified person Use at your own risk — race smart, stay safe.